Basic Stem & Handlebar Install Instructions

Things You Will Need

  • 4mm Hex key
  • Torque wrench

Assembly time, approximately 10 minutes. Difficulty: Easy.

SPECS

Geometry: 800mm Wide / 35mm Dia. / Sweep 8° Back 5° Up
Weight: 20mm Rise (220g) 35mm Rise (225g)
Max Stem Clamp Width: 65mm
Max Stem Clamp Torque: 6Nm
Max Lever Clamp Torque: 5Nm
Minimum Trim width: 740mm
Our Carbon bars have degrees etched into the stem clamp profile. These are designed to correspond with the headangle of your bike to create a neutral starting point for bar roll & to optimize the vertically compliance of the bar.

INSTALLATION

NOTE: These instructions are in reference to our Bar & Stem. If you are using a different stem please check the installation instructions for that stem. Not all stems clamp with no gap on the top clamp. Failing to install stem faceplates correctly can result in failure.

STEP 1:

With Stem face plate removed, install bar.

STEP 2:

Install Top bar clamp and bolts, tighten bolts to stem body until there is no gap between the stem body and face clamps.

STEP 3:

Thread lower bolts until bar is held in place, but can still roll easily.

STEP 4:

Find the corresponding marking to your frames headangle and line it up with the edge of the stem face plate.

If you are using a non-OneUp stem, you can also line up the markings with the edge of the stem face plate.

STEP 5:

Torque all stem bolts to 6Nm.

Note: It is highly recommended to check the torque spec twice before shredding!